CAN BUS Bridge Complete KIT

Complete CAN BUS KIT, with BTT EBB36/42 or MELLOW SB2040 v1 or BTT EBB SB2209 (NEW!) CAN Toolhead board, CAN BUS PTFE Harness and CAN Bridge RJ11 connector.

Useful if you want to bridge directly your Octopus board without using an USB to CAN adapter (like UTOC or Canable Pro boards). More infos about Klipper can bridge mode are available here and here

Features:

- BTT EBB36/42 or MELLOW SB2040 v1 or BTT EBB SB2209 (NEW!) CAN Toolhead board included

- RJ11 CAN Bridge connector included

- 20 AWG (19 Strands)and 24 AWG (19 Strands) genuine PTFE wires for connections of Huvud/BTT36-42/SHT36-42 (specifications in the pictures)

- (NEW!) 18AWG genuine PTFE wires (19 strands, silver plated copper, up to 13.5A, 300V, 200°C) for VCC/GND of MELLOW SB2040 v1 or BTT EBB SB2209 boards, 24AWG wires for DATA (CAN-L/CAN-H)

- Molex Microfit/Minifit connector to BTT EBB36/42; special connector for Mellow SB2040 v1 and BTT EBB SB2209

- Fork connectors for VCC and GND to PSU

- Ferrules connectors for CAN-L and CAN-H to CAN Bridge RJ11 connector

- All wires are properly labeled

OPTIONAL:

- (NEW!) UMBILICAL ADD-ON KIT  can be added

NOTE: We don't provide support for CAN BUS configuration on your printer; CAN BUS requires some experience and knowledge to get it working. We just sell the Hardware kit and, on request, we can flash the boards.

A good CAN BUS guide is available here

If you use a PT100 or a PT1000 sensor (es. Rapido hotend) you need a MAX31865 Integrated Circuit to read proper temperatures. MAX31865 is integrated on EBB SB2209 boards.  SB2040 v1 has a pull-up resistor for PT1000 only.  EBB36 and EBB42 boards comes without MAX31865.