Voron 2.4 complete PTFE wiring harness with CAN BUS

If you're building a new printer or want to upgrade to CANBUS communications without using lot of wires in drag chains this is the right harness for you, with TOP QUALITY PTFE wires and Hardware.

- True genuine PTFE wires (UL1180 - Datasheets and specifications attached)

• 20AWG wires (19 strands, silver plated copper, 8.5A max, 300V, 200°C) and 24 AWG for CAN BUS wiring
•  24AWG wires (19 strands, silver plated copper, 3.3A max, 300V, 200°C) for endstops and motors
•  (NEW!) 18AWG genuine PTFE wires (19 strands, silver plated copper, up to 13.5A, 300V, 200°C) for VCC/GND of MELLOW SB2040 v1 board or BTT EBB SB2209

- Wires are coded with colored heatshrink tubes and properly labeled (You won't get mad anymore!)

- All crimped connectors are checked (tensile strength test and electrical continuity test)

 Total of 17 wires  - 5 wires for CAN BUS cabling + 4 wires to X/Y Endstops + 8 wires to A/B Motors

What is included in the kit :

•  BTT EBB36/42 or MELLOW SB2040 v1 or BTT EBB SB2209 (NEW!  Ask if you want it in the kit (+20 EUR)) CAN Toolhead board and CANable Pro v1.0 USB to CAN adapter included
  

• ABS-Printed CANable Pro DIN-rail mount and clip

•  Counterparts Molex connectors and pins 

•  2 ABS-printed Molex connectors housing for A and B motors, very useful for a clean routing of A/B motors wires to the bottom of the back gantry

•  Z-Endstop PCB and XY-Endstops PCB included for all versions (Omron microswitches can be provided as option)

• ABS-printed Endstop POD for XY-Endstops PCB included

•  3 NeoPixel RGBW Mini Button PCB LEDS for new Stealthburner included for all versions (SB complete Led Kit or Rainbow BARF SB Led Kit can be added separately)

OPTIONAL:

- (NEW!) UMBILICAL ADD-ON KIT  can be added

- CANBOOT and Klipper firmware flashing (latest versions) on BTT EBB36/42 and CandleLight firmware flashing on CANable Pro boards. All flashed boards are connected and tested in a real CAN BUS chain.  Also canbus UUID will be provided.

NOTE: We don't provide support for CAN BUS configuration on your printer; CAN BUS requires some experience and knowledge to get it working. We just sell the Hardware kit and, on request, we can flash the boards.

If you use a PT100 or a PT1000 sensor (es. Rapido hotend) you need a MAX31865 Integrated Circuit to read proper temperatures. MAX31865 is integrated on EBB SB2209 boards.  EBB36-42/SB2040 v1 have a pull-up resistor for PT1000 only.  EBB36 and EBB42 boards comes without MAX31865.

Some basic instructions about the kit and how to configure it are available on our GitHub repo.

Please refer to official pages and Github repositories in order to flash the boards:

https://canable.io/updater/canable1.html     (select candlelight (a8a0757) firmware)

https://github.com/bigtreetech/EBB

https://mellow.klipper.cn/#/board/fly_sb2040/

A very good flashing guide for EBB36/EBB42 is also available here.