Voron TAP Complete Kit

NOTE: BOM and all printed parts are updated to latest Voron Tap release (R8).

Voron Tap Complete Kit.  All you need to setup your new nozzle probing system!  For Voron 2.4 and Trident.

Voron Tap is a nozzle probe that uses a 50mm MGN9 Linear rail between the X-carriage and the toolhead to allow the entire toolhead to move up a few millimeters, triggering an optical endstop or a mechanical switch. This kind of probing removes the need for an external z-probe (Inductive, Klicky, Euclid, etc.) as well as the need for an external Z-endstop (Microswitch, Sexbolt, etc.).

Videos of Voron Tap in action can be found here and here. 

Videos of Voron Tap installation are published here and here.

More infos about Voron Tap and assembly manual are available on official Github here.

What is included in the full kit (R8):

1  x 50mm MGN9 Rail - Stainless Steel 440C (Already cut to specifications and ready to use)

1  x MGN 9H Carriage (Z1 Preload)

4  x 6mm x 3mm N52 Magnet

12 x Heatset Inserts

3  x M3 Hex Nut

8  x M3 Washers

2 x M3 x 50 SHCS

2  x M3 x 20 SHCS screws

3  x M3 x 16 SHCS screws

3  x M3 x 12 SHCS screw

1  x M3 x 6 SHCS screw

2  x M3 x 6 FHCS screws

2  x M3 x 12 BHCS screws

2  x M3 x 8 BHCS screws

10 x M3 x 6 BHCS screws

1 x Omron D2HW-C203MR microswitch or Omron EE-SX398 sensor

Optional:

• VORON TAP ABS+ printed parts (R8) - can be added as optional to Complete Kits

  OptoTap PCB 5V v1.3 can be used with all CAN BUS boards or with Stealthburner Toolhead PCBs v4