Rainbow BARF HIGH DENSITY Stealthburner LED Kit
    search
    • Rainbow BARF HIGH DENSITY Stealthburner LED Kit
    • Rainbow BARF HIGH-DENSITY Stealthburner LED Kit
    • Rainbow BARF HIGH-DENSITY Stealthburner LED Kit
    • Rainbow BARF HIGH-DENSITY Stealthburner LED Kit
    • Rainbow BARF HIGH-DENSITY Stealthburner LED Kit
    • Rainbow BARF HIGH-DENSITY Stealthburner LED Kit
    • Rainbow BARF HIGH-DENSITY Stealthburner LED Kit

    Rainbow BARF HIGH-DENSITY Stealthburner LED Kit

    €32.00
    Delivery in 3 days

    Stealthburner LED Kit with NEW Rainbow BARF HIGH-DENSITY Logo LED (25 LEDS).

    Quantity

    help_outlineAsk about product
    Rainbow BARF HIGH-DENSITY Stealthburner LED Kit

    Rainbow BARF HIGH-DENSITY Stealthburner LED Kit

    Stealthburner LED Kit with NEW Rainbow BARF HIGH-DENSITY Logo LED (25 LEDS).

     

    redeem
    By buying this product you can collect up to 3 loyalty points . Your cart will contain total 3 points that can be converted into a voucher of €0.60 .


    Fully assembled LED kit for Stealthburner, with a chain of 2 NeoPixel RGBW Mini Button PCB LEDS and 1 Rainbow BARF HIGH-DENSITY (25 LEDS) (more infos about original Rainbow BARF here).

    The HIGH DENSITY Rainbow Barf Logo LED is a small PCB with 25 controllable leds (instead of 8) used on the logo of the Stealthburner, allowing more complex animations on it.

      

    Leds are connected by genuine PTFE wires and crimped with Microfit connector.

    - CLEAR RESIN LED diffuser and LED mask are included.

    - 100 Ohm resistor is also included in the package

     

    LED carrier STL can be found here.  A working BARF HIGH-DENSITY config file for Octopus v1.1 is available on our Github repository

    NOTE: Chain_count parameter should be set to 27 for BARF HIGH-DENSITY.   Color_order is RGB.

     

    Can be combined with Stealthburner LED wiring harness

      

    NOTEAll BARF led kits are tested before shipping by connecting them directly to an Octopus MCU. If you experience signal integrity issues you should add a 100 Ohm resistor to signal line, as close as possible to MCU (look at pictures).

    ELE-LED-BARFHD

    You might also like